Monthly Archives: August 2019


Hydraulic Valve Block Processing

What is the reason for the failure of hydraulic valve block processing? The processing failure of hydraulic valve block will affect all hydraulic systems. This paper summarizes the common phenomena of hydraulic valve block processing failure. 1. Hydraulic clamping When the pressure oil flows through the layout of the cylindrical slide valve of the hydraulic [...]

By |August 14th, 2019|Hydraulic Valve Block|Comments Off on Hydraulic Valve Block Processing

High Temperature Bearing Seat

Because the high temperature bearing seat should not only meet the requirements of high precision stamping bearing seat, but also meet the requirements of high temperature stamping bearing pedestal, the following two points should be taken into account when considering the fit and clearance of high temperature bearing seats: 1. Size change and hardness change [...]

By |August 8th, 2019|Bearing Pedestal, Bearing Seat|Comments Off on High Temperature Bearing Seat

Cleaning of Bearing Seats

Before the bearing seats are installed and guided, it should also be thoroughly cleaned and inspected. Scrape the dirt away with a scraper inside the bearing seat, wipe the dirt away with a cloth dipped in gasoline or solvent, and watch for cracks and sand holes to prevent oil seepage during operation. The joint surface [...]

By |August 6th, 2019|Bearing Block, Bearing Seat|Comments Off on Cleaning of Bearing Seats

Maintenance of Bearing Base

Special attention should be paid to the following points in the use of bearing base: 1. Use of cooling system of bearing base. When the cooling water of bearing seat is used correctly, not only the service life of bearing seat is prolonged, but also the production efficiency is improved. The material of bearing seat [...]

By |August 3rd, 2019|Bearing Chock, Bearing Seat|Comments Off on Maintenance of Bearing Base

Bearing Seat Wear

Bearing seat wear often occurs. Traditional repairing methods usually use machine-processing after surfacing to repair, and surfacing can make the surface of parts reach a high temperature, causing parts to deform or crack, and the downtime is greatly prolonged by machine-processing to obtain dimensions. The on-site repairing with polymer composites has neither thermal effect nor [...]

By |August 2nd, 2019|Bearing Pedestal, Bearing Seat|Comments Off on Bearing Seat Wear